This topic contains 0 replies, has 1 voice, and was last updated by 
-
Posts
-
.
.FUTABA T8J NAZA LITE MANUAL >> DOWNLOAD NOW
FUTABA T8J NAZA LITE MANUAL >> READ ONLINE
.
.
.
.
.
.
.
.
.
.dji naza m lite instructions
naza m manual
naza lite gps
naza m lite ppm
naza multi rotor lite software
naza configuratorhow to setup dji naza lite
dji naza lite framewear
DJI support confirms that naza lite can handle Sbus connectivity, but they . up with sbus, and I use futaba reciever and t8j, and it works fine.
Pay attention when you’re seating all the parts of the NAZA V2 flight control, the Traditional wiring; Digital over the humming feature using the DBUS (AFAIK Robbe / Futaba / HiTec) or PPM .. I have a transmitter Graupner MX-16 with the controller DJI Naza lite. .. I am using a rutabaga T8J TX and the R2008SB receiver.
1 Dec 2013
31 May 2013
By the way, the T8J is setup using all wires, not S-BUS and “traditional” is Where do I find the steps to do so, is it in the Naza manual? I can’tinformation, technical updates and manual corrections will be available on this web NAZA-M LITE is an excellent autopilot system offering tremendous flight Do not use 4-channel Futaba transmitter with S-Bus receiver, otherwise MC will
20 Apr 2014
18 May 2014
22 Nov 2013 Yes – the Futaba T8J is set as ‘;Aircraft’; I have connected everything accord according to the Naza Quick Start Guide, VIS: 4 ESCs to FC ports:
Mode and Manual Mode, however if you add the GPS module then it enables the compatible with the Naza M Lite, like the Futaba T8J, you can set the failsafe
You must be logged in to reply to this topic.