This topic contains 0 replies, has 1 voice, and was last updated by 
-
Posts
-
.
.MODE D’EMPLOI SHOWTEC LED OPERATOR 1 HOUR >> DOWNLOAD NOW
MODE D’EMPLOI SHOWTEC LED OPERATOR 1 HOUR >> READ ONLINE
.
.
.
.
.
.
.
.
.
.MCD Remote Operator Installation MG.17.E5.02 – VLT® is a registered Danfoss trademark 3 2.5. For use with MCD 200 In order to use the Remote Operator with MCD 200 so ft starters, a Remote Operator Module must first be installed to the starter using the following steps: 1. Remove control power and mains supply from the soft starter. 2.
5.2 Layout of IR controller’s buttons Oesc m 1 a fi 2b ~l fi menu H 4 d o *) 6 f n mem S 8p fi fi del fi Button Colour Description of function ESC ESC to one level up SELECTj Select device 0 – 9 Enter digits Switch between values, DP position, +/- Move up in the menu Move down in the menu OK Confirmation button Start 1 1 Pause Stop RESET Reset
5. 12/24 hour time format 6. Hour 7. Minutes 8. Year 9. Month 10. Date 11. Fahrenheit/Celsius 12. Language ENG-English or ESP-Spanish Note: When Atomic OFF is selected, you skip items 3 and 4 and go straight to 12/24 hour time format CST MST Time Zone Atlantic Eastern Central Mountain Pacific Alaska Hawaiian AST EST PST AKT HAT Note: Weekday
STEP 1 Open camera cover. Install 4 C-cell alkaline batteries. Make sure that the polarities on the batteries match the polarities indicated in the battery chamber. Recommended for use: Duracell® or Energizer ® batteries. STEP 2 Insert SD Memory Card until you hear an audible click. Camera will not operate without SD card. Slide the Mode The LED Operator 4 is a compact DMX controller for LED lights with 3 or 4 channel modes (RGB, RGBW or RGBA). It is an easy to operate controller with built-in sound activation and manual playback options. The LED Operator 4 can control fixtures in four different groups independently of each other so is extremely versatile for lighting operators.
Instruction Manual Mode d’emploi Digital Trail Camera Appareil photo numerique and set the time (the “hour” digits will flash, use Up/Down to set the hour and then minute. The time display uses the 24 hr standard, so 2:00 PM is indicated as “1400”, etc). LED Lock Tab Cam
You must be logged in to reply to this topic.