This topic contains 0 replies, has 1 voice, and was last updated by 
-
Posts
-
Download >> Download Rc heli after run oil instructions
Read Online >> Read Online Rc heli after run oil instructions
.
.
.
.
.
.
.
.
.
.traxxas after run oilhobbico after run oil
after run oil alternative
Nitro RC helicopters, also known as “Glow Powered” RC helicopters are still . mid, and high needle/mixture settings); Nitro Engine Care (after run oil, cleaning, . Now that you know a bit about nitro engines, let’s examine how they apply to
30 May 2011
11 Apr 2011 Tonight I dripped 2 or 3 drops of after run oil in my engine and spun it using WHat I usually do is put a fuel line on my bottle of after run oil (I don’t use WD-40 because I have various makes of RC’s and But my instructions should be pretty clear. .. Traxxas Aton · LaTrax Alias · DR1 and QR1 Helicopters.
After a hard day of running your RC, it is important to clear both the fuel tank and Apply about 30 drops of oil evenly to the top, bottom, and sides of the filter
4 Jul 2014 To apply after run oil first remove the glow plug. All that is needed is a few drops of after run oil into the glow plug hole in the top of the engine
Traxxas Monster Truck forum Discuss the Traxxas T-Maxx, E-Maxx, Super-Maxx and all other Traxxas monster trucks in this forum. remove your air filter and put it in the carb opening. I wasn’t quite sure where to put the after run oil in as well.
manual included with the model airplane, helicopter, or boat in which you intend .. For Glow engines, use an “after-run” oil when you’re fin- ished flying for theI’ve never used it on one of my heli engines, but I did on a plane engine. Inject afterrun oil into the fuel fill tube/fuel line just enough to fill the line. My R/C’s get stored for about 5 months and I have never used after run oil,
22 Jan 2012 Offroad Nitro Engine Forum – Mythbusters..After Run Oil – Ok let’s have at it. There seems to be a direct split amount Nitro RC guys about ARO.
I heard you put a few drops into the glow plug and a few into the carb? So what’s the correct procedure to do this? Do I need turn the engine on
You must be logged in to reply to this topic.